Maintenance; Lubricating The Edger; Changing The Edger Blade - Toro 08766 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine
from the normal operating position.

Lubricating the Edger

The edger cutter head has a grease fitting that must be
lubricated with #2 general-purpose, lithium-based grease
after every 100 hours of operation
Figure 14

Changing the Edger Blade

Check the edger blade frequently and replace the blade when
the blade width is reduced to 1-1/4 inches
1. Stop the machine, move the throttle control to the Slow
position and rotate the ignition key to Off, and remove
the key from the switch to prevent accidental starting.
2. Raise the edger to the transport position.
3. Remove the 4 screws and nuts that secure the blade to
the cutter arm (Figure
(Figure 14).
(Figure 15).
15).
1. Blade width
4. Install the new blade with the screws and nuts
previously removed.
12
Figure 15
2. Edger blade