Installing The Hose Guide; Routing The Hydraulic Hoses - Toro 08766 Operator's Manual

1. Cross tube
2. Hitch pin
2. Secure the cutter head to the cross tube with the hitch
pin (Figure 5).
3

Installing the Hose Guide

Parts needed for this procedure:
1 Hose guide
1 Flange nut
Procedure
1. Remove the bolt, washer, and nut securing the top
hydraulic tank clamp to the frame
and discard the clamp, bolt, washer, and nut.
Note: The hydraulic tank clamp may have been
removed in a previous step.
Figure 5
3. Cutter head
(Figure 6). Remove
1. Hose guide
2. Install the hose guide with the supplied flange nut.
Position the hose guide as shown in
4

Routing the Hydraulic Hoses

No Parts Required
Procedure
1. Route the hydraulic hoses through the hose guide and
to the rear of the machine
1. Hydraulic hoses
2. Hose guide
2. Connect the hoses to the rear remote connectors
(Figure 7).
Note: The hoses can be connected to either of the
connectors.
8
Figure 6
2. Hydraulic tank clamp
Figure 6.
(Figure 7).
Figure 7
3. Rear remote connectors