Table of Contents
Advertisement
Î Î Î Î
3
Figure 16
1. Air cleaner latches
2. Dust cap
2. Washing Method
A. Prepare a solution of filter cleaner and water and
soak the filter element about 15 minutes. Refer to
the directions on the filter cleaner carton for
complete information.
B. After soaking the filter for 15 minutes, rinse it with
clear water. Maximum water pressure must not
exceed 40 psi (276 kPa) to prevent damage to the
filter element. Rinse the filter from the clean side to
the dirty side.
C. Dry the filter element using warm, flowing air
(160°F [71°C] max), or allow the element to air-dry.
Do not use a light bulb to dry the filter element
because damage could result.
3. Compressed Air Method
A. Blow compressed air from the inside to the outside
of a dry filter element. Do not exceed 100 psi
(689 kPa) to prevent damage to the element.
B. Keep the air hose nozzle at least 2 in. (5 cm) from
the filter and move the nozzle up and down while
rotating the filter element. Inspect the filter for holes
and tears by looking through the filter toward a
bright light.
4. Inspect the new filter for shipping damage. Check the
sealing end of the filter. Do not install a damaged filter.
5. Insert the new filter properly into the air cleaner body.
Make sure that the filter is sealed properly by applying
pressure to the outer rim of the filter when installing it.
Do not press on the flexible center of the filter.
6. Install the cover and secure the latches. Make sure that
the cover is positioned with the TOP side up.
1
2
3. Filter
22
Adjusting the Throttle Control
Proper throttle operation is dependent upon proper
adjustment of the throttle control. Before adjusting the
carburetor, ensure that the throttle control is operating
properly.
1. Pivot the seat upward and remove the engine shield.
2. Loosen the cable clamp screw securing the cable to the
engine (Fig. 17).
3. Move the remote throttle control lever forward to the
Fast position.
4
3
1
2
Figure 17
1. Throttle casing clamp
screw
2. Throttle cable
3. Swivel
4. Pull firmly on the throttle cable until the back of the
swivel contacts the stop (Fig. 17).
5. Tighten the cable clamp screw and check the engine
RPM setting:
High Idle: 3150±50
Low Idle: 1750±50
Adjusting the Choke Control
1. Pivot the seat upward and remove the engine shield.
2. Loosen the cable clamp screw securing the cable to the
engine (Fig. 17).
3. Move the remote choke control lever forward to the
Closed position.
4. Pull firmly on the choke cable (Fig. 17) until the choke
butterfly is completely closed; then tighten the cable
clamp screw.
5
6
4. Stop
5. Choke casing clamp
screw
6. Choke cable
Advertisement
Table of Contents
