Sound Pressure; Sound Power; Vibration, Hand/Arm; Safety And Instructional Decals - Toro Super Recycler 20837 Operator's Manual

– whenever you leave the lawn mower.
– before refueling.
– before removing the grass catcher.
– before making height adjustment unless
adjustment can be made from the operator's
position.
• Stop the engine and disconnect the spark-plug wire.
– before clearing blockages or unclogging chute.
– before checking, cleaning or working on the lawn
mower.
– after striking a foreign object, inspect the lawn
mower for damage and make repairs before
restarting and operating the lawn mower.
– if lawn mower starts to vibrate abnormally (check
immediately).
• Lightning can cause severe injury or death. If you see
lightning or hear thunder in the area, do not operate
the machine; seek shelter.
• Watch out for traffic when crossing or near roadways.

Maintenance and Storage

• Keep all nuts, bolts and screws tight to be sure the
equipment is in safe working condition.
• Do not use pressure cleaning equipment on machine.
• Never store the equipment with gasoline in the tank
and inside a building where fumes can reach an open
flame or spark.
• Allow the engine to cool before storing in any
enclosure.
• To reduce the fire hazard, keep the engine, silencer,
battery compartment and gasoline storage are free of
grass, leaves, or excessive grease.
• Check grass catcher components and the discharge
guard frequently and replace with manufacturer's
recommended parts, when necessary.
• Replace worn or damaged parts for safety.
• Replace faulty silencers.
• If the fuel tank has to be drained, do this outdoors.
• Do not change the engine governor settings or
overspeed the engine. Operating an engine at
excessive speed can increase the hazard of personal
injury.
• Be careful during adjustment of the lawn mower to
prevent entrapment of the fingers between moving
blades and fixed parts of the lawn mower.
• To ensure the best performance and safety,
purchase only genuine Toro replacement parts
and accessories. Do not use will fit parts and
accessories; they may cause a safety hazard.

Sound Pressure

This unit has a sound pressure level at the operator's
ear of 85 dBA, which includes an Uncertainty Value (K)
of 1 dBA. The sound pressure level was determined
according to the procedures outlined in EN 836.

Sound Power

This unit has a guaranteed sound power level of 96 dBA,
which includes an Uncertainty Value (K) of 1 dBA. The
sound power level was determined according to the
procedures outlined in ISO 11094.

Vibration, Hand/arm

Measured vibration level for the left hand = 4.8 m/s
Measured vibration level for the right hand = 6.3 m/s
Uncertainty Value (K) = 2.5 m/s
The measured values were determined according to the
procedures outlined in EN 836.
Safety and Instructional
Decals
Important: Safety and instruction decals are
located near areas of potential danger. Replace
damaged decals.
Manufacturer's Mark
1. Indicates the blade is identified as a part from the original
machine manufacturer.
3
2
2
2