Adjusting The Handle Height; Adjusting The Cutting Height - Toro Super Recycler 20837 Operator's Manual

2. Remove the dipstick and check the oil level
(Figure 9).
If there is no oil on the dipstick, slowly pour oil
into the oil fill tube, periodically checking the level
with the dipstick, until the dipstick indicates that
the engine is full as illustrated in Figure 9. Do not
overfill. (Max. fill: 0.58 quart (0.55 l), type: SAE
30 detergent oil with an API service classification
of SH, SJ, SL, or higher.)
Note: If you overfill the engine, pour some oil out
of it as directed in Changing the Engine Oil.
3. Install the dipstick securely.

Adjusting the Cutting Height

WARNING
Adjusting the cutting height may bring you into
contact with the moving blade, causing serious
injury.
• Stop the engine and wait for all moving parts
to stop.
• Do not put your fingers under the housing when
adjusting the cutting height.
CAUTION
If the engine has been running, the muffler will be
hot and can severely burn you. Keep away from the
hot muffler.
Figure 9
Adjust the cutting height as desired.
Note: To raise the mower, move the cutting height
lever forward; to lower the mower, move the cutting
height lever rearward (Figure 10).
1. Cutting height lever
Note: The approximate cutting height settings are A=1
inch (25 mm); B=1-1/2 inch (38 mm); C=2 inches (51
mm); D=2-1/2 inches (64 mm); E=3-1/4 inches (83
mm); F=3-3/4 inches (95 mm); and G=4-1/4 inches
(108 mm).

Adjusting the Handle Height

You may raise or lower the handle to a position
comfortable for you.
Rotate the handle lock, move the handle to one of three
positions, and lock the handle into position (Figure 11).
7
Figure 10