Bagging The Clippings; Rear-Discharging The Clippings; Installing The Grass Bag - Toro Super Recycler 20837 Operator's Manual

1. Stop the engine and wait for all moving parts to stop.
2. Press the button on top of the Recycling/bagging
lever and move the lever to the recycling mode
(Figure 16).
1. Recycling mode

Bagging the Clippings

Use the grass bag to collect grass and leaf clippings from
the lawn.
WARNING
A worn grass bag could allow small stones and
other similar debris to be thrown in the operator's or
bystander's direction and result in serious personal
injury or death to the operator or bystanders.
Check the grass bag frequently. If it is damaged,
install a new Toro replacement bag.
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.
1. Stop the engine and wait for all moving parts to stop.
2. To bag the grass clippings, install the grass bag (refer
to Installing the Grass Bag). Press the button on top
of the Recycling/bagging lever and move the lever
to the bagging mode (Figure 16).
Figure 16
1. Bagging mode

Installing the Grass Bag

1. Stop the engine and wait for all moving parts to stop.
2. Raise and hold up the rear door, install the bag in the
notches, and lower the rear door (Figure 18).
Removing the Grass Bag
1. Stop the engine and wait for all moving parts to stop.
2. Lift up the grass bag up and away from the handle.
Note: Tilt the grass bag slightly backward to prevent
the collected grass clippings from falling out.
Rear-discharging the
Clippings
Use the rear discharge for cutting very tall grass.
If the bag is on the mower, remove it before
rear-discharging the clippings (refer to Removing the
Grass Bag).
Note: The Recycling/bagging lever should be in the
bagging mode (Figure 16).
9
Figure 17
Figure 18