Other Modes; Alarm Mode - Grundig Varixx UMS 4810 SPCD Manual

OTHER MODES

Alarm mode

Checking the alarm time
1
2
Interrupting and repeating the alarm
The duration of the alarm is 60 minutes regardless of the alarm type. You can interrupt the
alarm function. After every 9 minutes, the alarm sounds again.
1
Switching off the alarm
1
Activating and deactivating the alarm
1
2
20
Check the alarm time (in stand-by, tuner or CD mode) by pressing and holding down
»DISPLAY MODE« on the device until the set alarm time flashes.
e
– Display: » « flashes.
To end the display of the alarm time, press
current time or the input source appears in the display.
Move your hand over »SNOOZE
– Display: » «.
SNOOZE
– The alarm goes off again after 9 minutes.
Note:
You can interrupt the alarm as often as you like within the 60 minute alarm duration.
Press » « on the device while the alarm is sounding, until »
e
/
or
during the radio or CD alarm, press »
display, or press »ON/OFF« on the hi-fi to switch to stand-by mode.
To switch off the alarm for the following days, press »
goes out.
– The set alarm time is saved.
To activate the alarm, press »
or CD) appears in the display.
– The hi-fi system sounds daily at the set alarm time.
_______________________________________________
»DISPLAY
SENSOR« on the device to interrupt the alarm.
« on the device until »
e
/
« on the device until alarm source (signal tone, tuner
/ e
MODE« on the device until the
e
« disappears;
e
« goes out in the
« on the device until »
/ e
e
«