Preprogrammed Remote Control Codes; Entering Remote Control Codes; Remote Control Codes For Onkyo Components Connected Via Ri; Controlling Other Onkyo Components - Onkyo HT-R590 Instruction Manual

Controlling Other Onkyo Components
You can use the AV receiver's remote controller to
control your other Onkyo AV components. This section
explains how to enter the remote control code (with the
default underlined) for a component that you want to
control: DVD, CD, etc.
The following REMOTE MODE are preprogrammed
with remote control codes for controlling the components
listed. You do not need to enter a remote control code to
control these components.
For details on controlling these components, see the pages
indicated.
BD/DVD Onkyo Blu-ray Disc player (_ page 48)
TV/CD Onkyo CD player (_ page 48)
You'll need to enter a code for each component that you
want to control.
Onkyo components that are connected via f'41 are
controlled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
1 Make sure the Onkyo component is connected with
an f'41 cable and an analog audio cable (RCA).
See "Connecting Onkyo f'41 Components" for details
(_ page 16).
2
Enter tile appropriate remote control code for
REMOTE MODE referring to the previous section.
42157:
Onkyo cassette tape deck with f"/I
81993:
Onkyo Dock with f"/I
3 Press REMOTE MODE, point the remote
controller at the AV receiver, and operate the
component.
2
3
Look up the appropriate remote control code in the
Remote Control Codes for Onkyo Components
Connected via f'4 I.
While holding down REMOTE MODE to which
you want to enter a code, press and hold down
DISPLAY (about 3 seconds).
• Remote control codes cannot be entered for RECEIVER
• Apart fi'om RECEIVER, remote control codes fi'om any
category can be entered for REMOTE MODE. However,
these buttons also work as input selector buttons
(_ page 19), so choose a REMOTE MODE that
corresponds with the input to which you connect your
component. For example, if you connect your CD player to
the CD input, choose TV/CD when entering its remote
control code.
Within 30 seconds, use the number buttons to enter
the 5-digit remote control code.
The remote indicator flashes twice.
If the remote control code is not entered successfully,
the remote indicator will flash once slowly.
Controlling Onkyo components without R I
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that's not connected via f'4 I, use the
following remote control codes:
30627:
Onkyo DVD player without R I
71817:
Onkyo CD player without R I
32900/33000:
Onkyo Blu-ray Disc player
32901/33004
Onkyo HD DVD player
70868:
Onkyo MD recorder without 1-41
71323:
Onkyo CD recorder without 1-41
82990:
Onkyo Dock without f"/I
;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;
ER
47