Onkyo HT-R590 Instruction Manual page 53

m How do I change the language of a multiplex
source
Use the "Input Ch (Mux)" setting on the "Audio 37
Adjust" menu to select "Main" or "Sub".
m The R I functions don't work
To use 1"-41, you umst make all 1"-41connection and
an analog audio connection (RCA) between the
component and AV receiver, even if they are
connected digitally.
16
N The following settings can be made for the
composite video inputs
You must use the buttons on the unit to make these
settings.
On the AV receiver, press the input selector for the
input source that you want to set and the SETUP button
simultaneously. While holding down the input selector
button, press SETUP until "Video ATT:ON" appears
on the display. Then, release both buttons. To reactivate
the setting, repeat the above process so that "Video
ATT:OFF" appears on the display, and release the
buttons.
• Video Attenuation
This setting can be made for the BD/DVD, VCR/DVR,
CBL/SAT, GAME, or AUX input.
If you have a games console connected to the composite
video input, and the picture isn't very clear, you can
attenuate the gain.
Video ATT:OFF: (default).
Video ATT:ON: Gain is reduced by 2 dB.
N If the picture on your TV/monitor connected to
HDMI OUT is unstable, try switching the
DeepColor function off
To turn off the DeepColor function, simultaneously
press the CBL/SAT and OON/STANDBY buttons on
the AV receiver. While holding down CBL/SAT, press
r3ON/STANDBY until "Off" appears on the display.
Then, release both buttons. To reactivate the DeepColor
function, repeat the above process until "On" appears
on the display and release the buttons.
The AV receiver contains a microcomputer for signal
processing and control functions. In very rare situations,
severe interference, noise from an external source, or
static electricity may cause it to lockup. In the unlikely
event that this happens, unplug the power cord from the
wall outlet, wait at least five seconds, and then plug it
back in again.
l
Onkyo is not responsible for damages (such as CD
rental fees) due to unsuccessful recordings caused by
the unit's malfunction. Before you record important
data, make sure that the material will be recorded
correctly.
Before disconnecting the power cord from the wall
outlet, set the AV receiver to Standby.
]
EF1
53