Controlling Other Onkyo Components; Preprogrammed Remote Control Codes; Entering Remote Control Codes; Remote Control Codes For Onkyo Components Connected Via - Onkyo TX-SR313 Instruction Manual

Controlling Other Onkyo
Components
You can use the AV receiver's remote controller to control
your other Onkyo AV components. This section explains
how to enter the remote control code for a component that
you want to control: DVD, CD, etc.
Preprogrammed Remote Control
Codes
The following REMOTE MODE butttons are
preprogrammed with remote control codes for controlling
the components listed. You do not need to enter a remote
control code to control these components.
For details on controlling these components, see the
indicated pages.
BD/DVD Onkyo Blu-ray Disc player (➔ page
TV/CD Onkyo CD player (➔ page 53)

Entering Remote Control Codes

You'll need to enter a code for each component that you
want to control.
1
Look up the appropriate remote control code in the
Remote Control Codes for Onkyo Components
Connected via
2
While holding down the REMOTE MODE button to
which you want to assign a code, press and hold
down DISPLAY (about 3 seconds).
The remote indicator lights.
Note
• Remote control codes cannot be entered for RECEIVER.
• Except for RECEIVER remote control codes from any
category can be assigned to the REMOTE MODE button.
However, these buttons also work as input selector buttons
(➔ page 21), so choose a REMOTE MODE button that
corresponds with the input to which you connect your
52)
component. For example, if you connect your CD player to
the CD input, choose TV/CD when entering its remote
control code.
3
Within 30 seconds, use the number buttons to enter
the 5-digit remote control code.
The remote indicator flashes twice.
If the remote control code is not entered successfully,
the remote indicator will flash once slowly.
.
En-50
Controlling Other Components
Remote Control Codes for Onkyo
Components Connected via
Onkyo components that are connected via
controlled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
1 Make sure the Onkyo component is connected with
an cable and an analog audio cable (RCA).
See "Connecting Onkyo Components" for details
(➔ page 18).
2
Enter the appropriate remote control code for a
REMOTE MODE button, by referring to the
previous section.
42157:
Onkyo cassette tape deck with
81993:
Onkyo Dock with
3 Press the REMOTE MODE button, point the
remote controller at the AV receiver, and operate
the component.
are
To be continued