Side-Discharging The Clippings - Toro Recycler 20958 Operator's Manual

Operating the Bag-on-Demand Lever
The bag-on-demand feature allows you to either collect or
recycle grass and leaf clippings while the grass bag is attached
to the machine.
•
For bagging the grass and leaf clippings, press the button
on the bag-on-demand lever, and move the lever forward
until the button on the lever pops up (Figure 20).
Figure 20
1. Bag-on-demand lever (in bagging position)
•
For recycling the grass and leaf clippings, press the button
on the lever and move the lever rearward until the button
on the lever pops up.
Important: For proper operation, remove any grass
clippings and debris from the bag-on-demand door
and the surrounding opening (Figure 21) before you
move the bag-on-demand lever from one position
to another.
WARNING
The blade is sharp; contacting the blade can
result in serious personal injury. Also, an open
rear discharge area could allow small stones and
other similar debris to be thrown toward the
operator or a bystander, and result in serious
personal injury or death.
Stop the engine and wait for all moving parts to
stop before cleaning the bag-on-demand door
and the surrounding opening.
1. Clean here

Side-discharging the Clippings

Use the side discharge for cutting very tall grass.
If the grass bag is on the machine and the bag-on-demand
lever is in the bagging position, move the lever to the recycling
position; refer to Operating the Bag-on-Demand Lever (page
12).
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.
Installing the Side-discharge Chute
Lift up the side deflector and install the side-discharge chute
(Figure 22).
12
Figure 21