Starting The Engine; Using The Self-Propel Drive; Stopping The Engine - Toro Recycler 20958 Operator's Manual

1. Raise the machine
Note: The cutting-height settings are 25 mm (1 inch); 35
mm (1-3/8 inch); 44 mm (1-3/4 inch); 54 mm (2-1/8 inches);
64 mm (2-1/2 inches); 73 mm (2-7/8 inches); 83 mm (3-1/4
inches); 92 mm (3-5/8 inches); and 102 mm (4 inches).

Starting the Engine

Pull the recoil-start handle lightly until you feel resistance,
then pull it sharply (Figure 12). Allow the rope to return to
the handle slowly.
Note: If the machine does not start after several attempts,
contact an Authorized Service Dealer.
Figure 11
2. Lower the machine
Figure 12

Using the Self-propel Drive

To operate the self-propel drive, simply walk with your hands
on the upper handle and your elbows at your sides, and the
machine will automatically keep pace with you (Figure 13).
Note: If the machine does not freely roll backward after
self-propelling, stop walking, hold your hands in place, and
allow the machine to roll a couple of centimeters (inches)
forward to disengage the wheel drive. You can also try
reaching just under the upper handle to the metal handle and
push the machine forward a couple of centimeters (inches).
If the machine still does not roll backward easily, contact an
Authorized Service Dealer.

Stopping the Engine

Hold down the ignition switch in the "Stop" position until
the engine stops (Figure 14).
1. Ignition switch
9
Figure 13
Figure 14