Table of Contents
Advertisement
Set-Up Instructions
Installing the Seat
1.
Mount the seat to the seat base using two 5/16"
shoulder bolts and lock nuts (Fig. 1).
2.
Insert the seat switch wire through the center
opening in the seat base (Fig 1).
3.
Push the seat switch wire connector into the wire
harness connector.
1
2
6
Figure 1
1. Seat
2. Seat base
3. 5/16" shoulder bolt (2)
4. 5/16" Locknut (4)
Installing the Steering Wheel
1.
Install the boot washer onto the steering shaft
(Fig. 2).
2.
Remove the plastic trim cover from the steering
wheel (Fig. 2)
3.
Install the steering wheel onto the shaft,
carefully aligning the splines (Fig. 2).
2
3
5
4
m–3453
5. Seat switch wire
connector
6. Opening for seat switch
wire
Note:
There is no fixed straight ahead
position on power steering models.
4.
Secure the steering wheel to the shaft with a lock
washer and nut (Fig. 2). Tighten the retaining
nut to 45–50 ft–lbs.
5.
Install the trim cover on the steering wheel.
6
3
1
Figure 2
1. Boot washer
2. Steering shaft
3. Steering wheel
Checking Front Wheel Toe–In
1.
With the tractor on a level surface, check to
make sure the front wheel toe-in is between 1/8"
and 1/4". For instructions on adjusting toe-in,
refer to the Maintenance section in Operator's
Manual.
5
4
2
m–2482
4. Lock washer
5. Nut
6. Trim cover
Advertisement
Table of Contents
