Resistance Adjustment; How To Move The Vision V-Series - Vision Fitness V-SERIES Owner's Manual

Resistance adjustment:

The preferred level of diffi culty in pedaling (resistance) can be regulated in fi ne increments
by use of the resistance knob. To increase the resistance, turn the resistance knob
clockwise. To decrease the resistance, turn the knob counter clockwise.
IMPORTANT: To stop the fl ywheel while pedaling, push down the red resistance knob
in the center of the frame. The fl ywheel should quickly come to a complete stop. Please
make sure your shoes are fi xed into the toe clip.
The Vision V-Series indoor cycle does not have a free moving fl ywheel; the
!
pedals will continue to move together with the fl ywheel until the fl ywheel
stops. Reducing speed in a controlled manner is required. To stop the
fl ywheel immediately, push down the red resistance knob. Always pedal
in a controlled manner and adjust your desired cadence according to your
abilities.

How to move the VISION V-series:

Due to the weight of the Vision V-Series indoor cycle, it is recommended that two people
move it. While one person lifts the back of the cycle, the second person fi rmly holds the
handlebars and tips the cycle down until it rolls on the wheels. Carefully move the indoor
cycle to the desired location and lower it. CAUTION: To reduce the risk of injury, use
extreme caution while moving the indoor cycle. Do not attempt to move it over
uneven surfaces and make sure a safety space of a minimum of 20 inches to the
nearest equipment is achieved.
If the Vision V-Series indoor cycle rocks
on the fl oor after being set down, turn the
leveling feet (see diagram) underneath the
front or rear stabilizer until the rocking motion
is eliminated. Important:
unscrew the leveling feet more than ½ inch.
HOW TO OPERATE THE VISION V-Series
Resistance Knob (red)
Emergency brake
Please do not
V-SERIES
levelling feet
!
Page 13