Table of Contents
Advertisement
Step 1
Step 2
Step 3
Step 4
Step 5
The daily care regimen is the same for both interchangeable heads . When using
the ClearWave Soothing Skin System, care for each desired area of the skin for
the 3 minute cycle . You may care for a given area twice a day . For optimal results,
allow 24 hours before your next care cycle .
Operating Instructions
Proper Use Operations
Note:
• For best results, remove all make-up and wash your
face with a neutral pH cleanser.
• During use, hold the device in a single location until the
cycle is complete.
Step 1: To ACTIVATE, press the Power Button until the
device beeps once, indicating that the care
cycle is ready to begin .
Step 2: Apply protective eyewear (goggles) . Place over
cotton balls for added comfort .
Step 3: To START, place the device against the desired
area of your skin to receive care . The LED lights
will turn on and the cycle will begin once the
device is in full contact with your skin .
Step 4: Hold device firmly in place until the device
beeps twice signaling that the care cycle
is complete . Do not move the position of
the device on your skin . Device will beep if
removed from skin — see page 10 . If battery
runs low and shuts off unit, plug AC Adapter
directly into device and continue care cycle .
Step 5: Replace the ClearWave Soothing Skin System
to the Charging Stand to fully charge for the
next treatment .
Note: To manually turn OFF the ClearWave Soothing
Skin System prior to the end of a cycle, press and hold
the Power Button for approximately 3 seconds until the
device beeps twice.
Note: Device can be used when connected directly to
the AC Adapter. See page 11.
Daily Care for Your Skin
9
Advertisement
Table of Contents
