Replacing The Interchangeable Heads - Verilux ClearWave CWST2RB Instruction Manual

Replacing the Interchangeable Heads

Blemish Head
• 414nm of blue light soothes inflamed pores to help restore your skin to a healthy glow .
Fine Lines and Wrinkles Head
• 660nm of red light helps to reduce the appearance of pimples and blemishes and fine
lines and wrinkles deep in the skin .
Push and release
latch buttons
Note: If the Information Display shows three dashed lines "---", the
Interchangeable Head is incorrectly installed. Repeat the head removal and
installation process as outlined above.
Note: The device monitors each care cycle to ensure that the Interchangeable Head is
delivering a complete and effective dose. Once the LEDs have passed their guaranteed 100%
output life where a complete dose cannot be guaranteed, the Interchangeable Head will expire
and the device will cease to function until the Interchangeable Head is replaced.
The amount of care cycles remaining on an Interchangeable Head
is displayed both on the device's Information Display and on the
Interchangeable Head Life Indicator . When the bottom Interchangeable
Head Life Indicator Light is flashing and the Information Display is
displaying "0", the head needs to be replaced .
Replacement heads can be ordered directly from Verilux
ordering online at www .verilux .com .
To Remove the Interchangeable Head:
Step 1: Press and hold both Head Latch Buttons
shown on each side of the Head .
Step 2: Separate the Interchangeable Head from
the Device Body .
To Install an Interchangeable Head:
Step 1: Align the three round plastic posts on the
back of the Interchangable Head with the
three post sockets on the Device Body .
This will also align the square latch holes
on the interchangeable head with the
Head Latch buttons on the Device Body .
Step 2: Press and hold both Head Latch Buttons
on each side of the Head .
Step 3: Press the Head into place against the
Device Body and release the Head Latch
Buttons .
Step 4: Press Power Button for approximately
one second to activate Status Mode (see
page 7) . The Information Display should
now display the amount of
cycles remaining on the new
Interchangeable Head .
by calling 1-800-454-4408 or by
®
13