Charging Mode - Verilux ClearWave CWST2RB Instruction Manual

Note:
• To receive the optimal care cycle, fully charge the ClearWave
before use. A fully discharged device can require from 5 to 12 hours of charging time
to fully recharge battery.
• When the bottom Battery Life Indicator Light is flashing and the
Information Display is displaying "LO", the battery has lost its
charge. The unit will beep three times, then turn off.
• Device can be used in charging mode if connected
directly to the AC adapter.

Charging Mode

To Charge Using Charging Stand:
Step 1: Connect the AC adapter to the Charging
Stand and plug into a 120V grounded
electrical outlet .
Step 2: Place the device on the Charging Stand,
as shown .
Step 3: The Battery Life Indicator Lights will
provide information to you on the status
while charging .
Step 4: When all three Battery Life Indicator Lights
are illuminated (as shown), the battery is fully
charged and the device is ready for use .
To Charge and use WITHOUT
Charging Stand:
Step 1: Connect the AC adapter to the device and
plug into a 120V grounded electrical outlet .
Step 2: The Battery Life Indicator Lights will provide
information to you on the status while
charging .
Step 3: Device may be used while in charging mode,
if desired .
Step 4: When all three Battery Life Indicator Lights
are illuminated (as shown), the battery is
fully charged .
11
Soothing Skin System
®