Cold Protection Mode; Heat Protection Mode - Verilux ClearWave CWST2RB Instruction Manual

Soothing skin system

Hide thumbs Also See for ClearWave CWST2RB:

Table of Contents

When the "Information Display" is displaying "CP", the device

has been exposed to temperatures below -15° Celsius (5°F)

and will not operate properly . Set the device aside and allow it

to reach room temperature before using .

Note: Consecutive uses and high ambient temperatures

can cause the Interchangeable Head surface to become

warm to the touch. The device monitors the Head surface

temperature during each care cycle to ensure that the

Head maintains an optimum temperature. If the device

exceeds the optimum temperature limit, it will enter Heat

Protection Mode and the device will limit operation until

sufficient surface cooling has been achieved.

When the Information Display is displaying "HP", the device has reached its

optimum temperature limit and will not continue to operate until a cool down

period has been completed .

If your device enters Heat Protection Mode:

The Information Display will display "HP" and the device will beep 10 times and

immediately terminate the cycle .

Step 1: Set the device back on the Charging Stand and allow cooling .

Step 2: Once "HP" is no longer visible in the Information Display, the device

is ready for use .

Step 3: Resume normal operation as outlined on page 9 of this manual .

Cold Protection Mode

Table of Contents