Godox V860 Instruction Manual page 11

Using Fully Automatic Wireless Flash
The FEC and other settings that set on the master unit will also be
appeared on the slave unit automatically. The slave unit does not
need any operation. Use the following settings to make wireless
flashes according to the same methods with normal flash shooting.
● Flash Exposure Compensation (
● Flash Exposure Bracketing (
● Flash Exposure Lock (Page 41)
● High-Speed Sync (
SYNC
● Manual Flash (Page 43)
● Stroboscopic Flash (Page 44)
The firing frequency of stroboscopic flash during the optic
transmission shooting can be set from 1Hz to 199Hz.
Press Function Button 4 so that <
< > are displayed.
FEB
About Master Unit
Use two or more master units. By preparing several cameras that
with master units flash attached, cameras can be changed in
shooting while keeping the same lighting source (slave unit).
5.
ETTL: Use the Wireless Shooting of Flash Ratio
Auto Flash Shooting with Two Slave Unit
Divide the slave units into A and B groups and balance their shooting
illumination (flash ratio).
Auto control exposure to make the total output of A and B flash
groups up to standard exposure.
- 49 -
Page 40)
Page 41)
FEB
Page 42)
>和
>、< SYNC
1
Setting the flash groups of
slave unit.
● Set the flash as slave unit.
● Press Function Button 3
< Gr > and choose
<A> or <B>.
● Set one slave unit as <A>,
the other as <B>.
2
Setting < MENU 2 >.
● Step 2 to Step 4 are set on
the master unit.
● Press the Function Button
4 on the master unit so that
< MENU 2 > is displayed.
3
Setting <RATIO A:B>.
● Press Function Button 2
RATIO
< > so that
<RATIO A:B> is displayed.
Auto Flash Shooting with Three Slave Unit
C
A
B
About Slave Group Control
Slave Group A
ID=A ID=A ID=A
● When setting < RATIO A:B C >, group A, B and C will fire a
flash synchronously; when setting< RATIO A:B >, group C
will not fire a flash.
● If shooting under the situation that group C is toward the
main shooting subject, over exposure might occurred.
● In some EOS film cameras that support E-TTL autoflash,
you cannot perform multiple flash wireless shooting with a
flash ratio setting.
4
Setting flash ratio.
● Press Function Button 3
< Gr >.
● Turn the Select Dial to set
the amount of flash ratio
and press<SET> button to
confirm.
5
Taking the picture.
● The slave units will flash
according to the flash ratio.
1
Setting the slave group
<C>.
● Use the same method of
step 1 (Page 49) to set the
slave unit of flash
group<C>.
2
Setting <RATIO A:B C>.
● Use the same method of
step 1 and step 3 (Page
49) to set the master unit
as <RATIO A:B C>.
3
Setting flash exposure
compensation.
● Use the same method of
step 1 (Page 49) to set the
slave unit of flash
group<C>.
● Press Function Button 2
< >. Turn the Select
Dial to set the amount of
flash exposure
compensation and
press<SET> button to
confirm.
If three slave units are all set to
<A> in terms of slave ID, these
slave units will be controlled as if
they were one camera flash in
slave group A.
- 50 -