Starting And Stopping The Engine - Toro 30410 Operator's Manual

Figure 27
1. Front castor arm
Matching Height Of Cut Between Cutting Units
1. Position blade side to side on outside spindle of
both side cutting units. Measure from the floor
to the tip of the cutting edge on both units and
compare. These numbers should be within 1/8 inch
(3 mm) of each other. Make no adjustment at this
time.
2. Position blade side to side on inside spindle of side
cutting unit and corresponding outside spindle
of front cutting unit. Measure from the floor to
the tip of the cutting edge on inside edge of side
cutting unit to corresponding outside edge of front
cutting unit and compare. The side cutting unit
measurement should be approximately 3/8 inch
less than the front cutting unit measurement to be
correct. When proper machine counterbalance is
applied to the side cutting units the inside edge will
lift up approximately 3/8 inch (10 mm).
Note: All three side cutting units castor wheels
should remain on the ground with counterbalance
applied.
Note: If adjustments need to be made to match the
cut between the front and side cutting units, make
the adjustments to the side cutting units only.
3. If the inside edge of the side cutting unit is too
high relative to the outside edge of the front cutting
unit, remove one 1/8 inch shim from the bottom
of the front inside castor arm on the side cutting
unit (Figure 27). Recheck measurement between
outside edges of both side cutting units and inside
edge of side cutting unit to outside edge of front
cutting unit.
4. If inside edge is still too high, remove an additional
1/8 inch shim from bottom of front inside castor
arm of the side cutting unit and one 1/8 inch shim
from the front outside castor arm of the side cutting
unit.
5. If the inside edge of the side cutting unit is too low
relative to the outside edge of the front cutting unit,
add one 1/8 inch shim to the bottom of the front
inside castor arm on the side cutting unit. Check
measurement between outside edges of both side
cutting units and inside edge of side cutting unit to
outside edge of front cutting unit.
6. If inside edge is still too low, add an additional 1/8
inch shim to the bottom of front inside castor arm
of the side cutting unit and add one 1/8 inch shim
to the front outside castor arm of the side cutting
unit.
7. Once cutting height matches at the edges of front
and side cutting units, verify that side cutting unit
pitch is still 1/4 inch (6 mm). Adjust as necessary.
Starting and Stopping the
Engine
Important: The fuel system will automatically
bleed itself when any of the following situations
occur:
• Initial start up of a new machine.
• The engine has ceased running due to lack of fuel.
• Maintenance has been performed upon the fuel
system components.
1. Ensure that the parking brake is set. Remove your
foot from the traction pedal and ensure that it is in
neutral.
2. Move the throttle control to the mid-idle position.
3. Turn the ignition key to the Run position. The glow
indicator will light.
4. When the glow indicator dims, turn the ignition key
to the Start position. Release the key immediately
when the engine starts and allow it to return to the
Run position. Allow engine to warm up at mid
speed (without load), then move the throttle control
to the desired position.
Important: Do not run the starter motor
more than 15 seconds at a time or premature
starter failure may result. If the engine fails to
27