Table of Contents
Advertisement
2
3
1
Figure 7
1. Filler caps
2. UPPER line
Warning
Charging battery produces gasses that can
explode and cause serious injury.
Keep cigarettes, sparks and flames away from
battery.
Make sure the ignition switch is off.
Ventilate when charging or using battery in an
enclosed space.
7. Make sure the vent caps are installed in the battery.
Charge the battery for 1 hour at 25 to 30 amps or 6
hours at 4 to 6 amps. Do not overcharge the battery.
8. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the charger
leads from the battery posts (Fig. 8).
4
2
Figure 8
1. Positive Battery Post
2. Negative Battery Post
3. LOWER line
3
1
3. Red (+) Charger Lead
4. Black (–) Charger Lead
17
9. Install the battery in the machine and connect the
battery cables. Refer to Installing Battery on page 40.
Note: Do not run the machine with the battery
disconnected, electrical damage may occur.
Checking the Hydraulic Fluid
Check the hydraulic fluid level before engine is first
started.
Fluid Type: Mobil 1 15W-50 synthetic motor oil or
equivalent synthetic oil.
Important
Use oil specified or equivalent. Other
fluids could cause system damage.
Hydraulic System Oil Capacity: 67 oz. (2.0 l)
1. Position machine on a level surface and chock or block
tires.
2. Clean area around filler neck of hydraulic tank
(Fig. 9).
3. Remove cap from filler neck. Look inside to check if
there is fluid in the reservoir (Fig. 9).
4. If there is no fluid, add fluid to reservoir
approximately a 1/4 in. (6mm) below the top of baffle.
5. Run the machine 15 minutes to allow any air to purge
out of the system and warm fluid.
6. Recheck level while fluid is warm. Add fluid to raise
level to top of the baffle, if required.
Note: Fluid level should be to the top of the baffle when
fluid is warm (Fig. 9).
7. Install cap on filler neck.
Advertisement
Table of Contents
