Toro 30809 Operator's Manual page 38

•
Steering cylinder (Figure 46).
Note: If desired, an additional grease fitting may be
installed in the other end of the steering cylinder. Remove
the tire, install the fitting, grease the fitting, remove the
fitting, and install the plug (Figure 47).
•
Cutting unit spindle shaft bearings (2 per cutting unit)
(Figure 48)
Note: Either fitting can be used, which ever is more
accessible. Pump grease into the fitting until a small
amount appears at bottom of the spindle housing (under
the deck).
Figure 46
Figure 47
Figure 48
•
Rear roller bearings (2 per cutting unit) (Figure 49)
Note: Make sure the grease groove in each roller mount
aligns with the grease hole in each end of the roller
shaft. To help align the groove and hole, there is also an
alignment mark on one end of the roller shaft.
38
G011349
Figure 49