Table of Contents
Advertisement
Note: All height-of-cut pins can use two spacers
maximum.
1. Select hole in height-of-cut post and number of
spacers corresponding to the height-of-cut desired
(Figure 12).
2. Using the lift handle, raise side of deck and remove
hairpin cotter (Figure 12).
3. Add or remove spacers if needed and then align
holes and insert hairpin cotter (Figure 12).
Note: Spare height-of-cut spacers may be stored
on posts and retained by a hairpin cotter.
Important: All four hairpin cotter pins must be
in the same hole location and with the correct
number of spacers for a level cut.
Figure 12
1. Carrier Frame
2. Hairpin Cotter
3. Back height-of-cut post
Adjusting the Anti-Scalp
Rollers
The anti-scalp rollers need to be adjusted in the proper
hole location for each height-of-cut position. There
needs to be 3/8 inch (10 mm) minimum clearance
above the ground.
Note: If the anit-scalp rollers are adjusted too low can
cause excess wear of the rollers.
4. Spacers
5. Front height-of-cut post
1. After adjusting height-of-cut, check the anti-scalp
rollers so that there is a minimum of 3/8 inch (10
mm) clearance above the ground (Figure 13).
2. If adjustment is needed, remove the bolt, washers
and nut (Figure 13).
3. Select a hole position so the anti-scalp rollers are
a minimum of 3/8 inch (10 mm) off the ground
(Figure 13).
4. Install the bolt and nut (Figure 13).
1. Mower deck
2. Bolt
3. Spacer
Adjusting the Handle Height
The handle position can be adjusted to match the
operator's height preference.
1. Remove hairpin cotter, washer and clevis pin
securing control rod fitting to idler bracket
(Figure 14).
18
Figure 13
4. Anti-Scalp Rollers
5. Nut
Advertisement
Table of Contents
