Toro 30031 Operator's Manual page 39

Commercial walk-behind mower floating deck, t-bar, gear with 91cm turbo force cutting unit
Hide thumbs Also See for 30031:
Table of Contents

Advertisement

4. Measure engine deck height at location A (Figure 52).
1. Back view of machine
2. Top of engine deck
5. Measure engine deck height at location B (Figure 52).
6. If the height at location A and B are not the same,
change tire pressure slightly to make them the same.
Checking the Carrier Frame
Front-to-Rear Pitch
The carrier frame must have a pitch between 1/8 inch
(3 mm) to 3/8 inch (9 mm) over the length of 24 inches
(61 cm) on the carrier frame (Figure 53).
1. Measure out 24 inches (61 cm) on the carrier frame
(Figure 53).
1. Carrier Frame
2. 1/4-3/8 inch (6-10 mm)
pitch over 24 inch (61 cm)
length
3. 24 inches (61 cm)
2. Measure carrier frame height at location A
(Figure 53).
Figure 52
3. Tires
4. Same height at locations
A and B
Figure 53
4. Height at locations A and
B
5. Caster Wheel
6. Caster spacers
3. Measure carrier frame height at location B
(Figure 53).
4. The height at location A must be a 1/4-3/8 inch (6
mm -10 mm) lower than location B (Figure 53).
5. If the carrier frame is not correct, move caster
spacers to make it a 1/4-3/8 inch (6 -10 mm) pitch
(Figure 53). Move spacers from top or bottom to
make the correct pitch.
6. The tire pressure may also be adjusted slightly to
make a 1/4 inch (6 mm) pitch.
Checking the Carrier Frame
Side-to-Side Height
The carrier frame needs to be parallel side-to-side from
the ground.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Adjust the tire pressure in the rear tires to
specifications; refer to , page .
4. Measure carrier frame height at location A
(Figure 54).
5. Measure carrier frame height at location B
(Figure 54).
6. If the carrier frame height is not the same move
spacers from top or bottom of caster wheel, to
make it level. The tire pressure may also be adjusted
slightly to make it level.
1. Caster Wheel
2. Carrier Frame
3. Front height-of-cut pins
39
Figure 54
4. Same height at locations
A and B
5. Caster spacers

Advertisement

Table of Contents
loading

Table of Contents