Installation And Connection - Bosch HMT 85G650 Instruction Manual

Installation and connection

This appliance is only intended for domestic use.
This oven is intended for built in use only. It is not
intended for counter top use or for use inside a
cupboard.
Please observe the special installation instructions.
The appliance can be installed in a 60 cm wide
wall mounted cupboard (at least 30 cm deep and
85 cm off the floor).
The appliance is fitted with a plug and must only be
connected to a properly installed earthed socket. The
fuse protection must be rated at 10 amperes
(automatic circuit breaker with trigger characteristic L
or B). The mains voltage must correspond to the
voltage specified on the rating plate.
The socket must only be installed and the connecting
cable must only be replaced by a qualified electrician.
If the plug is no longer accessible following
installation, an all pole disconnecting device must be
present on the installation side with a contact gap of
at least 3 mm.
Adapters, multiway strips and extension leads must
not be used. Overloading can result in a risk of fire.
95
Downloaded From Microwave-Manual.com Manuals