Positioning The Seat; Adjusting The Motion Control; Levers; Pushing The Machine By Hand - Toro 74603 Operator's Manual

Figure 14
1. Gage wheel
2. Stud
3. Washer
B. Select a hole so that the gage wheel is
positioned to the nearest corresponding
height-of-cut desired (Figure 14).
3. Install the stud nut and washer (Figure 14).
4. Repeat the adjustment on the other gage
wheels.

Positioning the Seat

The seat can move forward and backward.
Position the seat where you have the best control
of the machine and are most comfortable.
1. Raise the seat and loosen the adjustment knobs
(Figure 15).
2. Move the seat to the desired position and
tighten the knobs.
Figure 15
1. Adjustment knobs
Adjusting the Motion
Control Levers
The motion control levers can be adjusted higher
or lower for maximum operator comfort.
G000911
4. Nut
5. Wheel nut and washer.
Do not remove.
1. Remove the 2 screws and curved washers
holding the control lever to the control arm
shaft (Figure 16).
2. Move the control lever to the next set of holes.
Secure the lever with the 2 screws and curved
washers. The cupped side of the washer should
be toward the control arm shaft (Figure 16).
3. Repeat the adjustment on the other control
lever.
Figure 16
1. Control lever
2. Screw
Pushing the Machine by
Hand
Important: Always push the machine
by hand. Never tow the machine because
damage may occur.
To Push the Machine
1. Disengage the blade control switch and move
the control levers to the neutral locked position
and apply the parking brake.
2. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3. Pull the two bypass levers up and push them
until the washer on the rod passes through the
slot. Push the levers down to lock them in
place (Figure 17).
4. Disengage the parking brake to push the
machine.
18
3. Curved washer
4. Control arm shaft