Front Wheel (For Non-Abs Models) - Yamaha MT-125 Owner's Manual

Periodic maintenance and adjustment
Front wheel (for non-ABS
models)
WARNING
For the ABS model, have a Yamaha
dealer remove and install the wheel.
To remove the front wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the front wheel axle pinch
6
bolts, then the wheel axle and the
brake caliper bolts.
ZAUM1215
1. Axle bolt
2. Front wheel axle pinch bolt A
3. Front wheel axle pinch bolt B
EAU44792
EWA14841
EAU56531
EWA10822
3
ZAUM1192
1. Brake caliper bolt
2. Brake caliper
2. Lift the front wheel off the ground
according to the procedure in the
previous section "Supporting the
motorcycle".
3. Remove the brake caliper by re-
moving the bolts. NOTICE: Do
not apply the brake after the
wheel and brake disc have been
removed, otherwise the brake
pads will be forced shut.
4. Pull the wheel axle out, and then
remove the wheel.
To install the front wheel
1. Lift the wheel up between the fork
legs.
2. Insert the wheel axle.
3. Lower the front wheel so that it is
on the ground.
4. Install the brake caliper by install-
ing the bolts.
TIP
Make sure that there is enough space
between the brake pads before install-
ing the brake caliper onto the brake
disc.
5. Tighten the wheel axle to the
specified torque.
6-38
[ECA11073]