Specifications - Toro 30071 Operator's Manual

Blade Control Switch (PTO)
The blade control switch (PTO) is used to engage
the electric clutch to drive the mower blades with the
right side motion control lever in the center, un-locked
position. Pull the switch up to engage the blades and
release. To disengage the blades, push the blade control
switch (PTO) down or move or release the right side
motion control lever into the neutral lock position.
Ignition Switch
This switch is used to start the mower engine and has
three positions: Start, Run and Off.
Motion Control Levers
The motion control levers are used to drive the machine
forward, reverse, and turn either direction.
Neutral Lock Position
The neutral lock position is used with the safety interlock
system to engage and disengage the mower blades and
to determine neutral position.
Fuel Shut-off Valve
Close the fuel shut-off valve (under the fuel tank ) when
transporting or storing the mower.
Hour Meter
Shows the total hours the machine has been operated.
This operates only when the mower blades are operating.
The hour meter will flash 3 hours before and after a
service interval. The service intervals are set for the
first 8 hours, every 100 hours there after, and every 400
hours.
Note: Make sure maintenance is done at all
recommended intervals shown in the Recommended
Maintenance Schedule.
Attachments/Accessories
A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.

Specifications

Note: Specifications and design are subject to change
without notice.
Width with deflector down
Length
Height
Weight
10
51–1/8 inches (130 cm)
78–1/2 inches (199 cm)
46 inches (117 cm)
667 lb (303 kg)