Servicing The Spark Plugs - Toro 30071 Operator's Manual

1. Drain the oil from the engine; refer to Changing the
Engine Oil.
2. Remove the old filter (Figure 24).
1. Oil filter
3. Apply a thin coat of new oil to the rubber gasket on
the replacement filter (Figure 24).
4. Install the replacement oil filter to the filter adapter,
turn the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter an
additional 3/4 turn (Figure 24).
5. Fill the crankcase with the proper type of new oil;
refer to Servicing the Engine Oil.
6. Run the engine for about 3 minutes, stop the engine,
and check for oil leaks around the oil filter and drain
valve.
7. Check the engine oil level and add oil if needed.
8. Wipe up any spilled oil.

Servicing the Spark Plugs

Service Interval/Specification
Service Interval: Every 100 hours
Ensure that the air gap between the center and side
electrodes is correct before installing the spark plug.
Use a spark plug wrench for removing and installing the
spark plugs and a gapping tool/feeler gauge to check and
adjust the air gap. Install a new spark plugs if necessary.
Type: Champion® RCJ8Y or equivalent Air Gap:
0.030 inch (0.75 mm)
Removing the Spark Plugs
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
Figure 24
2. Adapter
3. Disconnect the wires from the spark plugs
(Figure 25).
1. Spark-plug wire/spark plug
4. Clean around the spark plugs to prevent dirt from
falling into the engine and potentially causing
damage.
5. Remove the spark plugs and the metal washers.
Checking the Spark Plugs
1. Look at the center of the spark plugs (Figure 26).
If you see light brown or gray on the insulator, the
engine is operating properly. A black coating on the
insulator usually means that the air cleaner is dirty.
2. If needed, clean the spark plug with a wire brush to
remove carbon deposits.
1. Center electrode insulator
2. Side electrode
24
Figure 25
Figure 26
3. Air gap (not to scale)
1