Replacing The Fuses; Replacing The Headlights - Toro 07299 Operator's Manual

Storing the Batteries
Charge the batteries fully before placing the machine into
storage. Plug the charger into a wall outlet while the machine
and batteries are in storage. Leave the charger plugged into a
wall outlet and charging receptacle during storage to ensure
that the batteries stay charged and do not freeze; otherwise,
charge the batteries at least once every 3 months.

Replacing the Fuses

There are 2 fuses in the electrical system. They are located
beneath the dash on the driver's side (Figure 30).
Open
Power Point
Lights and Horn
2
G021810
Figure 30
1. Machine fuse holder

Replacing the Headlights

Before performing any maintenance set the parking brake,
turn the On/Off switch to Off, and remove the key.
Release the retaining straps on the hood and raise the hood to
access the headlights.
Replacing the Bulbs
CAUTION
The halogen bulbs become extremely hot when in
operation. Handling a hot bulb can cause severe
burns and personal injury.
Always allow enough time to for the bulbs to cool
before replacing them. Use care whenever handling
the bulb.
10 A
10 A
10 A
1
2. Relay
CAUTION
Any surface contamination can damage the
headlight bulb and leading to its failure or explosion
creating a serious safety hazard.
Head light lamps should be handled without
touching the clear quartz, either by using a clean
paper towel or carefully holding the base.
Specification: See your Parts Catalog.
1. Disconnect the electrical harness from the bulb
housing on the back of the lamp.
2. Remove the protective rubber boot (Figure 31).
1. Headlight
2. Speed clip and flat washer 5. Rubber boot
3. Headlight bulb
3. Release the plastic retaining ring by turning it 1/4 turn
counterclockwise.
4. Remove the ring.
5. Remove the bulb assembly by moving it rearward, out
of the lamp housing.
6. Install a new bulb into the lamp housing.
Note: Use a paper towel to grasp the new bulb with
handling it to avoid contaminating the surface.
7. Secure the bulb in place by installing the retaining ring.
Note: Turn the ring 1/4 turn clockwise to lock it in
place.
8. Install the rubber boot over the ring and bulb.
9. Connect the bulb to the electrical harness.
29
Figure 31
4. Retaining ring
6. Headlight bulb harness
connection