Accessing The Hood; Lubrication; Adding Grease - Toro 07299 Operator's Manual

Accessing the Hood

1. Release the rubber straps on both sides of the hood
(Figure 25).
Figure 25
2. Raise the hood.
3. Lower the hood to close and use rubber retaining
straps to secure the hood.

Lubrication

Lubricate all of the bearings and bushings every 100 hours
or once a year, whichever occurs first. Grease them more
frequently when using the machine for heavy-duty operations.
Grease Type: Number 2 General Purpose Lithium-Base
Grease

Adding Grease

Service Interval: Every 100 hours
1. Wipe the grease fitting clean so foreign matter cannot
be forced into the bearing or the bushing.
2. Pump grease into the bearing or bushing.
3. Wipe off any excess grease.
The grease fittings are located at the 4 tie-rod ends (Figure
26) and the 2 king pins (Figure 27).
1. Grease fitting
26
Figure 26
Left side shown
2. Tie rod
Figure 27