Product Overview; Installing The Wheels - Toro 38537 Operator's Manual

Product Overview

2
5
3
4
6
7
9
1. Discharge chute
2. Chute crank
3. Control bar
4. Handle
5. Control panel
2
1
4
1. Key switch
2. Primer
1
8
m-6230a
6. Knobs
7. Handle bolt (2)
8. Rotor blades
9. Fuel tank cap
3
3. Recoil start
4. Choke lever
3329-465
5
Setup

Installing the Wheels

1. Turn the
snowthrower onto its
left side and place a
block under the left
axle end.
2. Slide the short
spacer (A) and a
wheel onto the right
axle end.
Note: The side of the
wheel with 6 spokes
must face downward.
3. Put a pushnut onto the end of the axle and use a
hammer to seat it firmly in place.
4. Turn the snowthrower onto its right side and place
a block under the right axle end.
5. Repeat steps 2 through 4 (see note below).
Note: Slide the long spacer and a wheel onto the left
axle end.
A
m-6217
m-6218