Installing The Fuel Tank And Shift; Lever Plate - Toro 30092 Operator's Manual

Figure 3
1. Upper handle
2. Rear frame
3. Flange nut, (3/8 inch)
4. Flange bolt, (3/8 x 1 inch)
Note: Handle assembly must be installed
before fuel tank is installed.
Step
2
Installing the Fuel Tank and
Shift Lever Plate
Parts needed for this step:
1 Fuel tank with studs installed
1 Shift lever plate
2 Bolt, (5/16 x 7/8 inch)
2 Lock nut, (5/16 inch)
4 Washer, (5/16 inch)
1 Hose clamp
2 Lock washer, (5/16 inch)
2 Spring
Procedure
1. Remove the bolts and nuts holding the shift
lever plate to the rear frame. Discard these
nuts and bolts.
2. Slide the shift lever plate over the shift lever
and under the bottom of the rear frame
(Figure 4).
3. Align fuel tank with the top of the rear frame
(Figure 4).
5. Upper mounting hole
6. Lower mounting holes
7. Low position
8. High position
Figure 4
1. Rear frame
2. Shift lever plate
Note: Remove the plastic cap from the fuel
fitting before installing the fuel line.
Figure 5
1. Fuel line
2. Hose clamp
4. Slide the hose clamp onto the fuel line
(Figure 5).
5. Push the fuel line onto the fuel tank connection
and secure it with a hose clamp (Figure 5).
6. Secure the right side of shift lever plate and
fuel tank to the rear frame with 2 bolts (5/16
x 7/8), lock washers (5/16 inch) and washers
(5/16 inch) (Figure 6).
7. Secure the left side shift lever plate and fuel
tank to the rear frame with washers (5/16 inch),
springs and locknuts (5/16 inch) Figure 6).
Note: Tighten left side of shift lever plate
until it is completely tight and then unscrew
the locknut one full turn. This will allow the
spring to work.
12
3. Gas tank
3. Fuel tting