Lubricating The Caster And Wheel; Bearings; Greasing The Transmission; Couplers - Toro 30092 Operator's Manual

2. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings with a rag. Make
sure to scrape any paint off the front of the
fitting(s).
4. Connect a grease gun to the fitting. Pump
grease into the fittings until grease begins to
ooze out of the bearings.
5. Wipe up any excess grease.
Lubricating the Caster and
Wheel Bearings
Lubricate the wheel bearings and front spindles
(Figure 23).
Figure 23

Greasing the Transmission

Couplers

Lubricate the transmission couplers located in the
back of the machine (Figure 24).
Figure 24
Greasing the Spindle
Bearing
Grease the spindle bearing through the hole in the
mower cover (Figure 25).
Figure 25

Engine Maintenance

Servicing the Air Cleaner

Service Interval/Specication
Foam element: Clean it after every 25 operating
hours.
Paper element: Check it after every 50 operating
hours. Replace it after every 200 operating hours
or yearly, which ever comes first.
28