Setup; Installing The Handle; Assembly - Toro 30092 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Handle assembly
1
Flanged bolt, (3/8 x 1 inch)
Flange nut, (3/8 inch)
Fuel tank with studs installed
Shift lever plate
Bolt, (5/16 x 7/8 inch)
Lock nut, (5/16 inch)
2
Washer, (5/16 inch)
Hose clamp
Lock washer, (5/16 inch)
Spring
3
No parts required
Control rods
Cotter pin
4
Clevis Pin
Washer
Hairpin cotter pin
Operator's Manual
Engine Operator's Manual
5
Parts Catalog
Safety Video
Registration Card
Note: Determine the left and right sides of the machine from the normal operating position.
Step
1

Installing the Handle

Assembly

Parts needed for this step:
1 Handle assembly
4
Flanged bolt, (3/8 x 1 inch)
4 Flange nut, (3/8 inch)
Procedure
1. Align handle with upper mounting holes in
rear frame (Figure 3).
Description
2. Secure the handle at each upper mounting hole
3. Select the low position for the lower mounting
4. Secure the handle at each lower mounting hole
11
Qty.
1
4 Install the handle assembly.
4
1
1
2
2
Install the fuel tank and shift lever
plate.
4
1
2
2
Check and adjust the shift lever
–
plate.
2
2
2
Install the control rods.
2
2
1
1
Read the Operator's Manual and
1
watch the video before operating
the machine.
1
1
with a flange bolt (3/8 x 1 inch) and flange nut
(3/8 inch)(Figure 3).
hole (Figure 3).
with a flange bolt (3/8 x 1 inch) and flange nut
(3/8 inch)(Figure 3).
Note: The handle position can be adjusted to
match the operator's height preference.
Use