1. Upper handle
2. Rear frame
3. Flange nut, (3/8 inch)
4. Flange bolt, (3/8 x 1 inch)
Note: Handle assembly must be installed before
fuel tank is installed.
2
Installing the Fuel Tank and
Shift Lever Plate
Parts needed for this procedure:
1
Fuel tank with studs installed
1
Shift lever plate
2
Bolt, (5/16 x 7/8 inch)
2
Lock nut, (5/16 inch)
4
Washer, (5/16 inch)
1
Hose clamp
2
Lock washer, (5/16 inch)
2
Spring
Procedure
1. Remove the bolts and nuts holding the shift lever
plate to the rear frame. Discard these nuts and bolts.
2. Slide the shift lever plate over the shift lever and
under the bottom of the rear frame (Figure 4).
3. Align fuel tank with the top of the rear frame
(Figure 4).
Figure 3
5. Upper mounting hole
6. Lower mounting holes
7. Low position
8. High position
1. Rear frame
2. Shift lever plate
Note: Remove the plastic cap from the fuel fitting
before installing the fuel line.
1. Fuel line
2. Hose clamp
4. Slide the hose clamp onto the fuel line (Figure 5).
5. Push the fuel line onto the fuel tank connection and
secure it with a hose clamp (Figure 5).
6. Secure the right side of shift lever plate and fuel
tank to the rear frame with 2 bolts (5/16 x 7/8),
lock washers (5/16 inch) and washers (5/16 inch)
(Figure 6).
7. Secure the left side shift lever plate and fuel tank to
the rear frame with washers (5/16 inch), springs and
locknuts (5/16 inch) Figure 6).
Note: Tighten left side of shift lever plate until it is
completely tight and then unscrew the locknut one
full turn. This will allow the spring to work.
11
Figure 4
3. Gas tank
Figure 5
3. Fuel fitting