Table of Contents
Advertisement
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Position the mower on the right side of the tractor.
4. Turn the front wheels fully to the left and raise
attachment lift lever or electric lift all the way up. Refer
to the tractor Operator's Manual.
5. Open the mid-mount hitch by pulling out the J–pin and
moving the lock handle rearward (Fig. 3).
1
Figure 3
1. Front hitch
2. Mid-mount hitch
6. Slide the mower under the tractor from the right side
and slide the attachment lift between the center and left
side level bar (Fig. 4).
7. Straighten the front wheels and lower the attachment lift
lever or electric lift to the mounting position; refer to
the tractor Operator's Manual.
8. Place the attachment lift pin into the slot in the center
lever bar and secure it with a washer (3/4 inch) and a
hairpin cotter (Fig. 4).
4
2
3
m–6622
3. J–pin
4. Lock handle
6
Figure 4
1. Attachment lift
2. Slot in center level bar
3. Washer
9. Rotate the front mounting shaft so the fork faces
straight up and aligned so the spacers are between the
mid-mount hitch plates (Fig. 5).
10. Lift the mower with the attachment lift lever or electric
lift and guide the fork to capture the hitch rod (Fig. 5).
11. Close the mid-mount hitch lock handle by rotating it
forward (Fig. 3).
4
Figure 5
1. Front mounting shaft
2. Fork
3. Spacer
Installing the Front Pulley Box
Install the front pulley box if it is not already installed.
1. Rotate the knobs to adjust the idler pulleys so there is a
1/4 inch (7 mm) clearance between the idler arms and
the mounting pins.
5
1
5
2
3
4
m–2824
4. Hairpin cotter pin
5. Left level bar
6. Right footrest
5
2
3
3
m–2825
4. Mid-mount hitch plate
5. Hitch rod
1
Advertisement
Table of Contents
