Table of Contents
Advertisement
Figure 13
1. Carrier frame
2. Hairpin cotter
3. Back height-of-cut post
Adjusting the Anti-Scalp
Rollers
The anti-scalp rollers need to be adjusted in the proper hole
location for each height-of-cut position. Ensure that the
minimum clearance above the ground is 10 mm (3/8 inch).
Note: Adjusting the anti-scalp rollers too low can cause
excess wear of the rollers.
1. After adjusting height-of-cut, check the anti-scalp
rollers so that there is a minimum of 10 mm (3/8 inch)
clearance above the ground
2. If adjustment is needed, remove the bolt, washers, and
nut
(Figure
14).
3. Select a hole position so the anti-scalp rollers are a
minimum of 10 mm (3/8 inch) off the ground
14).
4. Install the bolt and nut
4. Spacers
5. Front height-of-cut post
(Figure
14).
(Figure
(Figure
14).
1. Mower deck
2. Bolt
3. Spacer
Adjusting the Handle Height
The handle position can be adjusted to match the operator's
height preference.
1. Remove hairpin cotter, washer, and clevis pin securing
the control-rod fitting to the idler bracket
1. Control rod and fitting
2. Idler bracket
3. Clevis pin
2. Loosen the upper flange bolts (3/8 x 1 inch) and flange
nut securing the handle to the rear frame
18
Figure 14
4. Anti-scalp rollers
5. Nut
(Figure
Figure 15
4. Washer
5. Hairpin cotter
6. Rod fitting
(Figure
15).
16).
Advertisement
Table of Contents
