Table of Contents
Advertisement
Figure 49
1. Sail Area of Blade
2. Blade
3. Blade stiffener
Sharpening the Blades
1. Use a file to sharpen the cutting edge at both ends of
the blade
(Figure
50). Maintain the original angle. The
blade retains its balance if the same amount of material
is removed from both cutting edges.
Figure 50
1. Sharpen at original angle
2. Check the balance of the blade by putting it on a blade
balancer
(Figure
51). If the blade stays in a horizontal
position, the blade is balanced and can be used. If the
blade is not balanced, file some metal off the end of
the sail area only
(Figure
until the blade is balanced.
Figure 51
1. Blade
4. Curved washer
5. Blade Bolt
47). Repeat this procedure
2. Balancer
Installing the Blades
1. Install the blade onto the spindle shaft
Important: The sail part of the blade must be
pointing upward, toward the inside of the mower
to ensure proper cutting
2. Install the blade, stiffener, curved washer, and blade
bolt
(Figure
49).
3. Torque the blade bolt to 115-140 N-m (85-110 ft-lb).
Correcting the Mower Quality
of Cut
If one deck blade cuts lower than the other, correct as follows.
Note: Tire air pressure is critical in these procedures. Make
sure all tires have correct pressure.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Disconnect the spark plug wire(s) from the spark
plug(s).
4. Adjust the tire pressure in the rear tires to specifications;
refer to
Drive System Maintenance (page 28)
5. Check that the blades and spindle shafts are not bent.
Refer to
Checking for Bent Blades (page
6. Set the height-of-cut to the 101.6 mm (4 inch) position.
Refer to
Adjusting the Height-of-Cut (page
7. Perform the steps in the following sections:
up the Frame (page
Front-to-Rear Pitch (page
Mower Deck Front-to-Rear Pitch (page
Setting up the Frame
Checking the Carrier-Frame and
Engine-Deck Alignment
Note: Misalignment can cause excess wear on the PTO
drive belt.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Place a long straight edge on top of the engine deck as
shown in
Figure
4. At the carrier frame cross channel, measure the height
at location A
(Figure
Note: This measurement must be 33 mm (1-5/16
inch) plus or minus a 6 mm (1/4 inch).
5. If the height at location A is not correct, adjustment
is needed.
36
(Figure
(Figure
49).
35).
36),
Changing the Mower Deck
39), and
Changing the
39).
52.
52).
49).
.
17).
Setting
Advertisement
Table of Contents
