Table of Contents
Advertisement
6. Loosen the carrier frame mounting bolts on both sides
of the machine
(Figure
7. Align the carrier frame and engine deck to match 33
mm (1-5/16 inch) plus or minus a 6 mm (1/4 inch)
at location A
(Figure
8. Tighten the carrier frame mounting bolts on both sides
of the machine.
1. Carrier frame
2. Top of engine deck
3. Carrier-frame-mounting
bolts
Checking the Engine-Deck Height
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Adjust the tire pressure in the rear tires to specifications;
refer to
Drive System Maintenance (page
4. Measure engine deck height at location A
52).
52).
Figure 52
4. Location A, 33 mm (1-5/16
inch) ± 6 mm (1/4 inch)
5. Straight edge
6. Carrier-frame cross
channel
28).
(Figure
1. Back view of machine
2. Top of engine deck
5. Measure the engine-deck height at location B
53).
53).
37
Figure 53
3. Tires
4. Same height at locations
A and B
(Figure
Advertisement
Table of Contents
