Checking The Hydraulic Fluid; Greasing The Bearings; Checking The Side Discharge Chute; Checking The Level Of Mower Deck - Toro Z200 Z Master 74233 Operator's Manual

With 52" sfs side discharge mower
Table of Contents

Advertisement

4. Install valve cover screws into air cleaner bracket and
valve covers (Fig. 7).
Important
Tighten the valve cover screws to 70 in–lb
(5 N m) torque.
5. Remove plastic plugs from air intake elbow on engine
and air cleaner hose (Fig. 7).
6. Install hose to air intake elbow on engine and air
cleaner. Tighten hose clamps to secure the hose
connections (Fig. 7).
2
6
5
4
Figure 7
1. Air cleaner
2. Valve cover mounting
screws
3. Air cleaner bracket

Checking the Hydraulic Fluid

Check the hydraulic fluid level before the engine is first
started.
Refer to Checking the Hydraulic Fluid on page 35.

Greasing the Bearings

Important
Make sure cutting unit spindles are full of
grease before engine is first started.
Grease with No. 2 general purpose lithium base or
molybdenum base grease.
1. Grease the fittings on the three spindle bearings.
Grease until it comes out lower seals (Fig. 8).
1
2
3
m–4810
4. Air intake elbow
5. Air cleaner hose

6. Hose clamp

17
Figure 8
1. Spindles
Checking the Side Discharge
Chute
Remove plastic tie holding side discharge chute up and
lower into place.
Checking the Level of Mower
Deck
Check the level of the deck before the machine is first put
in use.
Refer to Mower Leveling and Compression Spring
Adjustment in the Maintenance section on page 43.

Checking the Engine Oil Level

Before you start the engine and use the machine, check
the oil level in the engine crankcase; refer to Checking Oil
Level, page 30.
1
M–5035

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

74233Z200 z master

Table of Contents