Operating The Power Take Off (Pto) - Toro Z200 Z Master 74233 Operator's Manual

2
1
m–4201
Figure 14
1. PTO-On
2. PTO-Off
1
2
m–2720
Figure 16
1. Throttle–Fast
2. Throttle–Slow
Stopping the Engine
1. Push the PTO to off (Fig. 16).
2. Move the throttle lever midway between the slow and
fast positions (Fig. 16).
3. Let the engine idle for 60 seconds (Fig. 17).
4. Turn the ignition key to off (Fig. 17).
5. Pull wire off spark plug(s) to prevent possibility of
someone accidentally starting the machine before
transporting or storing machine.
6. Close fuel shut off valve, on front panel before
transporting or storing machine.
Important
closed before transporting or storing the machine, as fuel
leakage may occur. Set the parking brake before
transporting. Make sure to remove the key as the fuel
pump may run and cause the battery to lose charge.
2
1
Children or bystanders may be injured if they
move or attempt to operate the tractor while it is
m–2719
unattended.
Figure 15
Always remove the ignition key and set the
1. Choke–On
parking brake when leaving the machine
2. Choke–Off
unattended, even if just for a few minutes.
Operating the Power Take Off
(PTO)
1
2
The power take off (PTO) switch engages and disengages
power to the electric clutch.
3
Engaging the PTO
1. While seated in the seat, release pressure on the
M–4268
2. Place throttle to the fast position.
Figure 17
3. Pull out on the power take off (PTO) switch to engage
1. Off
2. Run
3. Start
1. PTO—Off
Disengaging the PTO
1. To disengage push the PTO switch to the off position
20
Make sure that the fuel shut off valve is
Caution
traction control levers and place in neutral.
(Fig. 18).
1
Figure 18
(Fig. 18).
2
m–4201
2. PTO—On