Inspecting Belts; Replacing The Deck Belt; Replacing The Pto Drive Belt - Toro Z200 Z Master 74233 Operator's Manual

Note: When properly adjusted, the front blade tip will be
slightly lower than the rear blade tip. See Checking for
Bent Blades on page 27 to measure.
1
3
Figure 59
1. 19–17/32 inch (496 mm)
outside swivels
2. Top chain bolt
10. Recheck that blocks just fit just under the mower and
that tension on all four chains is approximately equal.
Tighten chain attachment bolts securely.
11. Measure height of cut. This can be checked with the
same procedure as Checking for Bent Blades on
page 27.
12. Install anti–scalp rollers for proper height-of-cut and
tighten securely.
Compression Spring Adjustment
1. Raise deck lift lever to the transport position (Fig. 58).
2. Springs are compressed so the distance between the
two large washers should be 10–1/4 inch (260 mm)
(Fig. 59).
3. Adjust by turning nut in front of each spring (Fig. 59).
Clockwise will shorten spring; counter–clockwise will
lengthen spring.
Cleaning Under the Deck
Remove grass build up under deck daily.
1. Position mower on a flat surface. Stop the engine, set
the parking brake, remove the key and disconnect the
spark plug wire(s) from the spark plug(s).
2. Raise deck to the transport position.
3. Clean the deck.

Inspecting Belts

Inspect all belts every 100 hours.
4
2
m–3747
2
3. Front swivel
4. 10–1/4 inch (260 mm)
spring compressed
1. Check belts for cracks, frayed edges, burn marks or
any other damage. Replace damaged belts.

Replacing the Deck Belt

Squealing when the belt is rotating, blades slipping when
cutting grass, frayed belt edges, burn marks and cracks are
signs of a worn deck belt. Replace the deck belt if any of
these conditions are evident.
1. Stop the engine, set the parking brake, remove the key
and disconnect the spark plug wire(s) from the spark
plug(s).
2. Remove the PTO drive belt. Refer to Replacing the
PTO Drive Belt, on page 44.
3. Loosen two nuts securing idler plate and move the
idler arm to relieve belt tension on the idler pulley,
then remove the worn deck belt (Fig. 60).
4. Install the new deck belt around the spindle pulleys,
belt guide, the idler pulley, and in the lower groove of
the center spindle pulley (Fig. 60).
5. Using a socket and torque wrench, rotate the idler
adjusting nut until torque is 25–30 ft.–lb.
(34–41 N m). Tighten two nuts.
1
Figure 60
1. Deck Belt
2. Idler Arm
6. Reinstall the PTO drive belt. Refer to Replacing the
PTO Drive Belt, page 44.

Replacing the PTO Drive Belt

Squealing when the belt is rotating, blades slipping when
cutting grass, frayed belt edges, burn marks and cracks are
signs of a worn drive belt. Replace the PTO drive belt if
any of these conditions are evident.
1. Stop the engine, set the parking brake, remove the key
and disconnect the spark plug wire(s) from the spark
plug(s).
44
4
2
M–4312
Top View
3. Idler nuts
4. Idler adjusting nut
3