Setup; Loose Parts; Installing Drive Wheels; Checking The Tire Pressure - Toro Z200 Z Master 74233 Operator's Manual

Setup

Note: Determine the left and right sides of the machine
from the normal operating position.

Loose Parts

Note: Use the chart below to verify all parts have been shipped.
DESCRIPTION
Rear Wheels
Retaining rod
Bolt, 5/16 x 1 inch
Locknut, 5/16 inch
Control lever-right
Control lever-left
Bolt, 3/8 x 1 inch
Spring washer, 3/8 inch
Air Filter
Hose Clamp
Key
Operator's Manual
Engine Operator's Manual
Parts Catalog
Registration card

Installing Drive Wheels

1. Uncrate the mower.
2. Remove wheel nuts from rear wheel hubs.
3. Align holes. Mount drive wheels with the valve stem
to the outside of the traction unit.
4. Secure using wheel nuts provided. Torque to 95 ft-lb
(128 N M).
Important Make sure that wheel nuts are torqued to
95 ft-lb (128 N M).

Checking the Tire Pressure

Check the air pressure in the front and rear tires (Fig. 2).
Pressure: 13 psi (90 kPa)
QTY.
2 Installing wheels to traction unit
1
1

Installing the seat retaining rod

1
1
1
Installing the motion control levers
4
4
1
Installing the air cleaner
1
2
1 Read before operating machine
1
1
1 Fill out and return to Toro
Installing the Seat Retaining
Rod
1. Tilt the seat up. Remove the locknut (5/16 inch) from
bolt attaching seat retaining rod to seat frame (Fig. 3).
14
USE
1
Figure 2
1. Valve stem
m-1872