Adjusting The Shift Lever Plate - Toro 30314TE Operator's Manual

Step
5
Checking and Adjusting the
Shift Lever Plate
Parts needed for this step:
None
Procedure
1. Shift lever to second gear and check alignment of
lever in slot of shifter lever plate. The clearance
between top and bottom of the shift lever should be
equal (Fig. 11).
2. If clearance is not correct, remove lever and bend it
slightly to adjust (Fig. 11).
1
2
Figure 10
1. Shift lever
2. Shift lever plate
3. Rubber seal washer
Note: Do not bend lever while attached to transmission
shaft or damage may occur.
3. Shift lever to neutral and check alignment of lever in
slot of shifter lever plate. The clearance on the sides of
shift lever should be equal (Fig. 11).
4. If clearance is not correct, loosen shift lever plate and
adjust it side–to–side. Tighten the shift lever plate.
6
5
4
3
m–5250
4. Square hole washer
5. Spring washer
6. Locknut, 3/8 inch
18
1
4
4
3
Figure 11
1. Shift lever, 2nd gear
2. Shift lever plate
2
Rear View
2
m–7454
3. Shift lever, neutral
4. Equal distance