Checking And Adjusting The Shift Lever Plate - Toro 30318 Operator's Manual

3
2
1
Figure 5
1. Bolt, 5/16 x 7/8 inch
2. Lock washer, 5/16 inch
3. Washer, 5/16 inch
4. Slide the hose clamp onto the fuel line (Fig. 6).
5. Push the fuel line onto the fuel tank connection and
secure it with a hose clamp (Fig. 6).
3
Figure 6
1. Fuel line
2. Hose clamp
Step
4
Checking and Adjusting the
Shift Lever Plate
Parts needed for this step:
None
m–3771
4
3
5
6
4. Stud
5. Spring
6. Locknut
2
1
m–6442
3. Fuel fitting
16
Procedure
1. Shift lever to second gear and check alignment of lever
in slot of shifter lever plate. The clearance between top
and bottom of the shift lever should be equal (Fig. 8).
2. If clearance is not correct, remove lever and bend it
slightly to adjust (Fig. 8).
1
2
Figure 7
1. Shift lever
2. Shift lever plate
3. Rubber seal washer
Note: Do not bend lever while attached to transmission
shaft or damage may occur.
3. Shift lever to neutral and check alignment of lever in
slot of shifter lever plate. The clearance on the sides of
shift lever should be equal (Fig. 8).
4. If clearance is not correct, loosen shift lever plate and
adjust it side–to–side. Tighten the shift lever plate.
1
4
4
3
Figure 8
1. Shift lever, 2nd gear
2. Shift lever plate
6
5
4
3
m–5250
4. Square hole washer
5. Spring washer
6. Locknut, 3/8 inch
2
Rear View
2
m–7454
3. Shift lever, neutral
4. Equal distance