Toro 30314TE Operator's Manual page 14

Step
1
Removing the Shipping
Bracket and Shipping Washers
Parts needed for this step:
None
Procedure
1. Remove the center gage wheel nut, 2 large washers,
angle bracket and 1 small washer (Fig. NO TAG).
Discard the 2 large washers and the angle bracket.
1
3
4
Figure 2
1. Center Gage Wheels and
Spacer
2. Nut
2. Install the center gage wheels with the previously
removed bolt, spacer, small washer, and nut (Fig. 3).
5
3
2
m–7585
3. Large washer—discard
4. Angle bracket—discard
5. Small washer
14
3
4
1
m–7660
Figure 3
1. Center Gage Wheels and
Spacer
2. Nut
3. Remove the hairpin cotter and washer on both front
height–of–cut posts (Fig. 3). Discard the washers,
these are not to be used for adjusting the
height–of–cut.
4
5 2
3. Bolt
4. Washer
5. Spacer