Adjusting The Center Gage Wheels; Adjusting The Handle Height; Using The Mid-Size Weight Kit - Toro 30314TE Operator's Manual

Adjusting the Center Gage
Wheels
The gage wheels need to be adjusted in the proper hole
location for each height-of-cut position. There needs to be
3/8 inch (10 mm) clearance above the ground.
1. After adjusting height-of-cut, check the gage wheels so
that there is a minimum of 3/8 inch (10 mm) clearance
above the ground (Fig. 23).
2. If adjustment is needed, remove the bolt, washers and
nut (Fig. 23).
3. Select a hole position so the gage wheels are a
minimum of 3/8 inch (10 mm) off the ground
(Fig. 23).
4. Install the bolt, washers and nut (Fig. 23).
3
4
1
Figure 23
1. Center Gage Wheels and
Spacer
2. Nut

Adjusting the Handle Height

The handle position can be adjusted to match the
operator 's height preference.
1. Remove hairpin cotter, washer and clevis pin securing
control rod fitting to idler bracket (Fig. NO TAG).
2. Loosen the upper flange bolts (3/8 x 1 inch) and flange
nut securing handle to rear frame (Fig. 24).
3. Remove the lower flange bolts (3/8 x 1 inch) and
flange nuts securing handle to rear frame (Fig. 24).
4. Pivot handle to desired operating position and install
lower flange bolts (3/8 x 1 inch) and flange nuts into
mounting holes. Tighten all flange bolts.
4
2
m–6366
3. Bolt
4. Washer
25
4
6
1
3
7
8
Figure 24
1. Upper handle
2. Rear frame
3. Flange nut, 3/8 inch
4. Flange bolt, 3/8 x 1 inch
5. Thread rod fitting up or down on rod until proper
position is attained and install into fitting to idler
bracket with clevis pin, washer and hairpin cotter.
Refer to Installing the Control Rod on page NO TAG.
6. Check the parking brake adjustment (Fig. NO TAG).
Refer to Checking the Brakes, page 32.
Using the Mid–Size Weight Kit
A weight kit is available for this machine. This kit is
optional and can be obtain from an Authorized Service
Dealer.
Installing this weight kit can improve performance on
slopes.
Note: For this machine install the weight kit only in the
front position.
5
2
m–6403
5. Upper mounting hole
6. Lower mounting holes
7. Low position
8. High position