Coffee Preparation; Timer Function - WMF LINEO Operating Manual

Note: You can also brew coffee immediately after connecting the mains plug to a
socket by briefly pressing the start / stop button.
Note: The time must be reset after a power failure or after the mains plug has been
unplugged.
You can always adjust the time setting.
Press the Set button and hold this down for approx. 4 seconds until Set flashes on
the display.
Now set the desired time by pressing the h and min buttons and confirm by pressing
the Set button.

Coffee preparation

You can remove this in order to easily fill the water tank. Open the water tank by
pressing on the lid. Only pour cold water into the tank. The water level indicator is
for the amount of fresh water that is needed to brew the desired number of cups per
125 ml coffee.
Swing out the filter to fill with ground coffee. Place the paper filter of the 1 x 4 size
into the filter, but fold the stamped edge before doing so. The paper filter should not
protrude over the edge of the filter, which is why it should be pushed down slightly
with your hand.
Fill with the required amount of ground coffee. Depending on personal taste, you
can figure about 5-7 g of medium-fine ground coffee per cup. If it is ground too
finely, the filter can overflow.
Then close the swing filter. It will audibly click into place.
Immediate start
Briefly press the start / stop button if the coffee is to be prepared immediately. The
LED illuminates with full luminance and the preparation begins.
You can cancel the preparation at any time by pressing the Start / Stop button..
Wait a few minutes until all of the coffee has run into the pot. After removing the
pot, a drip-stop prevents coffee from dripping.

Timer function

The device's timer function starts the brewing process automatically at the desired
time. The switch-on time can be programmed up to 24 hours in advance.
Programming the switch-on time
Press the Set button once briefly. Set and
appears in the display. Set the desired
time h and min and confirm the switch-on time by pressing the Set button.
If the switch-on time is not confirmed with Set , then Set will flash in the display.
After about 5 seconds, the display switches back to the time without saving a
switchon time.
Note: The switch-on time must be reset after a power failure or after the mains plug
has been unplugged.
Activate timer function
If the preparation should start automatically at the programmed switch-on time,
briefly press the button and will appear in the display.
The LED of the start / stop button illuminates with reduced luminance.
The preparation begins automatically at the programmed switch-on time. The LED
of the start / stop button illuminates with full luminance.
12