Marantz PM6006 Owner's Manual page 35

Contents Connections
Setting remote control codes for the
remote control
o To set the remote control codes to AMP2
1
Hold down REMOTE MODE CD and the number 2
button for more than 5 seconds.
o To set the remote control codes to AMP3
1
Hold down REMOTE MODE CD and the number 3
button for more than 5 seconds.
0 To return the remote control code to the default setting, hold down REMOTE
MODE CD and the number 1 button for more than 5 seconds.
NOTE
0 The remote control codes returns to the default settings when the batteries are
removed. Set the remote control codes again after replacing the batteries.
Front panel Rear panel
Playback Settings
Setting remote control codes for this
unit
1
35
Remote control
unit
Tips
Point the remote control for which the remote control
code was set at this unit, and press REMOTE MODE CD
and ENTER.
The input indicators on the unit flash as shown below according to
the set remote control code.
Remote control
codes
AMP 1 PHONO indicator flashes three times
AMP 2 CD indicator flashes three times
AMP 3 NETWORK indicator flashes three times
Index
Appendix
Input indicator